INT 13h,  01h (1)        Get Disk System Status                           all

Returns status information about the most recent fixed or floppy disk
operation.

On entry:      AH         01h
DL         Drive number

Returns:       AH         Status of operation (see below)
CF         Set if error, otherwise cleared

                                                                          
                          Status of Operation (AH)

AH             Meaning
FFh            Sense operation failed             (fixed)
E0h            Status error                       (fixed)
CCh            Write fault                        (fixed)
BBh            Undefined error                    (fixed)
80h            Drive not ready
40h            Seek failure
20h            Controller failure
11h            ECC corrected data error           (fixed)
10h            CRC or ECC data error
0Fh            DMA arbitration level out of range (fixed)
0Eh            Control data address mark detected (fixed)
0Dh            Invalid number sectors on format   (fixed)
0Ch            Media type not found               (floppy)
0Bh            Bad cylinder found                 (fixed)
0Ah            Bad sector flag detected           (fixed)
09h            Attempt to DMA across a 64K boundary
08h            DMA overrun
07h            Drive parameter activity failed    (fixed)
06h            Diskette change line active         (floppy)
05h            Reset failed                       (fixed)
04h            Sector not found
03h            Attempt to write on write-protected disk
02h            Address mark not found
01h            Invalid command
00h            No error
                                                                          

Notes:         The most recent diskette operation status is found
at 0:441h. The most recent fixed disk operation
status is at 0:474h.

For the AT, XT-286, and PC Convertible, the BIOS
executes INT 15h, Service 90h (Device Busy), for the
diskette (Type = 01h) and the fixed disk (Type =
00h) prior to waiting for the interrupt. INT 15h,
Service 91h (Interrupt Complete), is executed upon
completion. Also diskette operations that require
the diskette motor to be on will call INT 15h,
Service 90 (Device Busy), with the type equal to
"Diskette Drive Motor Start" (Type = FDh). This
allows the system to perform another task while the
drive motor is waiting to get up to speed.

See also: INT 13h, 00h
See also: 0:441h
See also: 0:474h

INT 13h, 01h (1) Get Disk System Status all