This tells the driver to read data from the device media and transfer it
to a specified buffer.

DevReq04Rec
Offset Size Contents
                                                                          
+0      1  bLen         20H or 14H (length of this request packet)
+1      1  bUnitNo      (not used)
+2      1  bCmd         04H (command code)
+3      2  rStatus      OUTPUT: Device Status Word must fill before exit
+5H     8  res          (reserved)
+0dH     1  bMediaID     INPUT: Media Descriptor DOS thinks is there
+0eH     4  pfBuffer     INPUT: buffer address
+12H     2  wReadSize    INPUT: number of bytes or sectors to read
OUTPUT: bytes or sectors actually read
                               Block Devices Only
+16H     2  wStartSect   INPUT: starting sector (ffffH=use lBigSect)
+18H     4  pfVolID      OUTPUT: addr of Volume ID for this unit/media
+1cH     4  lBigSect     INPUT: starting sector (when wStartSect=ffffH)
32               size of this structure

rStatus  On exit, the driver must place a DevStatusWord here.  Always
set the Done bit (bit 8).  On an error, set the Done bit and
the Error bit (bit 15) and put a Device Error Code in the low
byte.

bMediaID  On entry, this contains the Media Descriptor byte of the disk
that DOS thinks is in the drive.

pfBuffer  is the address of a buffer in which the driver may place the
requested data.  You must not store more than wReadSize bytes
(or sectors of block devices) here.

wReadSize  on entry, specifies how much data to transfer into pfBuffer:
Character devices: requested number of bytes
Block devices: requested number of sectors

On return, fill this with the actual amount of data you
transferred (bytes or sectors)
                                            Block Devices Only
wStartSect  Starting logical sector number to read (see INT 25H).  If the
sector number is larger than 65,535, this will contain ffffH
and you should use lBigSect as the 32-bit starting sector
number.  Used by block devices only.

pfVolID  Block devices which return Device Error Code of 0fH should set
this to the address of an ASCIIZ  volume ID of the disk that
should be in the drive (so DOS can prompt to insert that
disk).  Used by block devices only.

lBigSect  When DOS requests a logical sector number larger than 65,535,
it sets wStartSect to ffffH and puts the actual desired
starting sector number in here.  Used by block devices only.

Notes:   It is up to the driver to translate the "logical sector number"
to head/track/sector values actually used on the device and to
access sequential sectors using that numbering scheme.  See
INT 25H for the standard way to do this.

  This is the device driver "catch-point" for DOS read fns such
as 3fH (read from device or file).

See Also: Device Requests
- -

Device Request 04H: Input (Read Data from Device)